Headband Holder

So here it is the long awaited NO SEW headband holder!!

I love it!!

Here's what you'll Need:

• Oatmeal container (or i've also used a brand new paper towel roll )
• Fabric
• High or low loft batting
• Magnets
• Ribbon 
• Fake flowers
• Glue gun

First take you batting and cut out a piece long enough to go around the oatmeal container 

Start Gluing! 

Once you finish it should look about like this

Next cut your fabric, i cut mine 15 inches wide by 20 inches long (i probably could of cut it a little shorter but it still worked just fine)

Next- i will admit i was feeling a little lazy and instead of going All the way downstairs to sew up the raw edges(on one of the short ends)  I just HOT GLUED it, fold over and glue and then fold it over once more and glue - it worked amazing! yay for glue guns :)

 Next start gluing your fabric in place starting with the side that has the raw edge (not the one you just glue hemmed) Also make sure there is an even amount of fabric on each of the ends.

Here's what it will be looking like.... with your nicely glued seam on the back

Next you will glue the ends down. 

Lookin good! 

This is totally optional but i put a ribbon on it for hair clips gluing just the ends to the backside. 

Next i decided how long i wanted the ribbon that would hold it up (i just eyeballed it) and then glue one end of the ribbon to one side. 

Next glue your flower (or other decoration on the end over the ribbon you just glued on.

Moving to the other end- glue on one of your magnets 

Then grab another flower and glue the other end of the ribbon on top of the flower 

And then glue another magnet on top of the ribbon

This will make one end removable to slide headbands on and off. 

Then make it pretty with headbands and clips! I think i might need to make a longer one ;) or just stop making headbands....lol

So easy....made in under an hour!

Mine will make it's home in the bathroom on the towel ring that's just waiting to be used, where will yours go?